No. 99MBG518A
G-5
PART G : 1 Home Screen
1.2
Simple Screen
This screen is a simple screen to display test results in a large size and judge GO/NG for a single test.
Use this screen to repeatedly test the same specimen and judge GO/NG.
No. Name Details
①
Hardness value Displays test results.
If external output is set to a value other than [OFF], press and hold
to perform external output.
For details about external output, see "3.3 External Output"
(page G-30).
②
Scale Displays the scale that is currently set (indenter/test force).
To change the test method, see "5.2 Test Method" (page G-50).
To change the scale, see "2.1 Scale" (page G-13).
③
[Continuous] button Touching the [Continuous] button activates the display and enables
testing. For details, see "5 Executing Continuous Tests" (page
C-37) in "PART C Rockwell Hardness Test, Plastic Hardness Test
(ISO2039-2)".
④
[Run] button When continuous testing is enabled, this button can be used for
subsequent points. Touch the [Run] button to start a test.
⑤
GO/NG judgment Displays GO/+NG/–NG for the test results.
For details, see "3.2.1 GO/NG Judgment" (page G-28).
⑥
Clear button Press the clear button to delete the hardness value (test results)
currently displayed.
⑦
[Setting] button Displays the condition number that is currently set.
For details, see "5.6.1 System Conditions" (page G-56).
⑧
Status icon Displays the currently set functions as icons.
Icon Name Description
Admin. mode
Displayed when [Admin. mode] is [ON].
For details, see "5.4 Equipment" (page G-53).
Rounding
Displayed when [Rounding] is enabled for the smallest
digit.
For details, see "5.3 Display" (page G-51).
External output: USB
Displayed when [USB] in the external output settings is
set to [Automatic].
For details, see "3.3 External Output" (page G-30).
External output: Serial
Displayed when [Serial] in the external output settings is
set to [Automatic].
For details, see "3.3 External Output" (page G-30).
To Next Page
Loading...
