Mitutoyo HR-530 Series - Page 228

No. 99MBG518A
G-4
PART G : 1 Home Screen
No. Name Details
⑪
Position Ifthene-adjustmenttableforJominytestingisconnectedtotheINX
of the rear panel, the position is displayed.
- - - - - mm is displayed if not connected.
For details, see "1.5 Multi-Test Screen (When the Fine-Adjustment
Table for Jominy Testing is Connected)" (page G-11).
Icon Name Description
Admin. mode
Displayed when [Admin. mode] is [ON].
For details, see "5.4 Equipment" (page G-53).
Rounding
Displayed when [Rounding] is enabled for the smallest
digit.
For details, see "5.3 Display" (page G-51).
External output: USB
Displayed when [USB] in the external output settings is
set to [Automatic].
For details, see "3.3 External Output" (page G-30).
External output: Serial
Displayed when [Serial] in the external output settings is
set to [Automatic].
For details, see "3.3 External Output" (page G-30).
External output: SPC
Displayed when [SPC] in the external output settings is
set to [Automatic].
For details, see "3.3 External Output" (page G-30).
External output: USB memory
Displayed when [USB memory] in the external output
settings is set to [Automatic].
For details, see "3.3 External Output" (page G-30).
Curve correction: Cylinder
Displayed when [Cylind] is enabled for [Curve C.].
For details, see "2.3 Correction" (page G-23).
Curve correction: Sphere
Displayed when [Sphere] is enabled for [Curve C.].
For details, see "2.3 Correction" (page G-23).
User correction: Multi-point
correction
Displayed when [Multi.] is enabled for [User C.].
For details, see "2.3 Correction" (page G-23).
User correction: Shift
Displayed when [Shift] is enabled for [User C.].
For details, see "2.3 Correction" (page G-23).