Mitutoyo HR-530 Series - Calibrations to Run Plastic Hardness Tests; Replacing the Protective Sheet for the Display Unit

No. 99MBG518A
H-9
PART H : 3 Inspection and Replacement of Consumable Parts
3.3
Calibrations to Run Plastic Hardness Tests
Customers who wish to run plastic hardness tests need to calibrate the testing machine periodically.
Calibrate the testing machine in accordance with the following standards:
y ISO 2039-2 (JIS K 7202-2)
y ASTM D785
3.4
Replacing the Protective Sheet for the Display Unit
After the test is complete, check the state of the protective sheet for the display unit.
Replace the protective sheet if it is particularly dirty or if the display unit is hard to see.
1
Holdthegripontheprotectivesheetwithyourngersandslowlypeeltheprotectivesheeto󰀨.
2
A󰀩xanewprotectivesheet.
Fordetailsabouttheproceduretoa󰀩xtheprotectivesheet,see "5ProceduretoA󰀩xtheProtective
Sheet for the Display Unit" (page B-13) in "PART B Installation".
Tips
ConrmthetablebelowandcontactthenearestMitutoyosaleso󰀩ceaboutthereplacementprotectivesheet
for the display unit.
Part No. Number of sheets
12BAL402 1
12AAN040 10