Mitutoyo HR-530 Series - Connecting the Printer (DP-1 VA LOGGER

No. 99MBG518A
B-10
PART B : 4 Connection of Various Cables
4.2
Connecting the Printer (DP-1VA LOGGER)
CAUTION
• A Mitutoyo service engineer will connect each connector and perform the wiring during delivery and instal-
lation. In the event a connector becomes disconnected, the connector needs to be connected as shown in
the diagrams. If you have any questions or concerns about the connection of each connector or the wiring,
contactthenearestMitutoyosaleso󰀩ce.
• Disconnect the power cable from the power input connector of the testing machine when connecting each
connectorandperformingwiring.Conrmtheuser'smanualforeachdeviceandperformtheprocedures
aftershuttingo󰀨thepowersupply.Checkwhetherthewiringbetweenconnectorsiscorrect,allthewires
have been connected, and whether there are any poor connections when making connections to connect the
connectors.
NOTICE
An error is displayed if the connector for Digimatic data output (OUT) of the HR-530 series is connected to the
connector for data output of the DP-1VA LOGGER. If the error is displayed, check the connection of the connec-
tors.
①
No. Name Function
①
Connector for Digimatic
data output
Use the connecting cable for the connector for Digimatic data
output to connect the DP-1VA LOGGER.