Mitutoyo HR-530 Series - Method to Set a Group and Test Multiple Points; Test Method Settings

No. 99MBG518A
D-21
PART D : 3 Method to Set a Group and Test Multiple Points
3
Method to Set a Group and Test
Multiple Points
This chapter explains an example of the case of executing a plastic hardness test (ASTM
D785-B) on multiple points set as a group. By setting a group, the average value of multiple
test results can be output as one data value. When calculating the average value, it is possi-
ble to exclude the maximum and minimum values. In the actual test, set the test force speci-
edinthetechnicaldrawing,etc.
Setting item Setting value (example)
Test Method ASTM D785-B
Display [List Ave.] (or [List])
Scale α–p
Number group 5
Tips
Thetestforceoftheplastichardnesstest(ASTMD785-B)is60N(xed).
3.1
Test Method Settings
Set the test method.
For details about setting methods, see
"2.1 Test Method Settings" (page D-6).