Mitutoyo HR-530 Series - Checking the Levelness of the Testing Machine

No. 99MBG518A
B-7
PART B : 3 Checking the Levelness of the Testing Machine
3
Checking the Levelness of
the Testing Machine
The level check of the testing machine should be performed only by a Mitutoyo service engineer.
WARNING
In order to prevent the testing machine from falling over, we recommend installing the fall-prevention bolts on
the bottom of the rear side (two lateral positions: ø10 holes) of the testing machine.
CAUTION
Donotinsertyourhandsorngersintothegapunderthetestingmachinewhenturningthelevelingboltsorthe
fall-prevention bolts. They may become pinched.
1
Place the level in the center of the anvil.
①
②
No. Name
①
Anvil
②
Level