Mitutoyo HR-530 Series - Page 54

No. 99MBG518A
B-8
PART B : 3 Checking the Levelness of the Testing Machine
2
While looking at the level, use the wrench for leveling to turn the three leveling bolts (two loca-
tions on the left and right at the bottom of the front side and one location in the center of the
bottom of the rear side of the testing machine).
①
②
No. Name
①
Wrench for leveling
②
Leveling bolt
3
If the bottom of the rear side of the testing machine is secured with fall-prevention bolts (two
lateral positions: ø10 holes), use the wrench for leveling to turn the fall-prevention bolts. (After
theboltsgentlymakecontactwiththeoor,re-tightenslightlytocreateasmallgap.)
①
No. Name
①
Fall-prevention bolts
4
Ensure that the bubbles of the level are in the center.
5
If the bubbles are not in the center, perform the procedure from step 2 again.