Mitutoyo HR-530 Series - Drawing Settings for Histogram

No. 99MBG518A
G-43
PART G : 4 Results
No. Name Details
⑦
[V end] button Enters the maximum value of the vertical axis to draw (top end
value).
Enter a value when the number keys are displayed.
The end position of the vertical axis is in the top left of the graph.
⑧
Check box Sets the unit to display on the horizontal axis. This is active only
when the group measurement is disabled.
Cleared: Enters the minimum and maximum values of the number
axis.
Selected: Enters the minimum and maximum values of the coordi-
nates.
Tips
When selecting or clearing the check box, the setting is enabled after
touching the [OK] button and closing the screen temporarily. Open this
screen again to enter values.
⑨
[OK] button Closesthisscreenandreectsthedrawingsettingsinthegraph.
■Drawing settings for the histogram
② ③
①
④
⑤
⑥
⑦
No. Name Details
①
Histogram Indicates the graph to set in the drawing settings on this screen.
②
[Auto] button Setting for automatically drawing a graph.
The axis drawing settings cannot be set if set to automatic.
③
[Manual] button Touch this button to specify the axis drawing setting in this screen.
④
[Lower] button Enters the minimum value of the horizontal axis to draw.
Enter a value when the number keys are displayed.
⑤
[bin width] button Enters the width of the bars in the bar graph.
Enter a value when the number keys are displayed.
⑥
[num. of bins] button Enters the number of bars in the bar graph.
Enter a value when the number keys are displayed.
⑦
[OK] button Closesthisscreenandreectsthedrawingsettingsinthegraph.