Mitutoyo HR-530 Series - Page 308

No. 99MBG518A
J-2
PARTJ:1MainSpecications
Code HR-530 HR-530L
Code No. 810-233-20/810-233-21/810-233-23 810-333-20/810-333-21/810-333-23
Test force
(continued)
Brinell hardness test (indenting only)
Test force
N 61.29 980.7 153.2 245.2 294.2 306.5 612.9 980.7 1226 1839
(kgf) 6.25 10 15.625 25 30 31.25 62.5 100 125 187.5
Scale 1/10, 1/30, HB*2.5/6.25, 2.5/15.625, 2.5/31.25, 2.5/62.5, 2.5/187.5,
HB*5/25, 5/62.5, 5/125, HB*10/100
Plastic 1 hardness test
Preliminary test force Total test force
N 98.07 588.4 980.7 1471
(kgf) 10 60 100 150
Scale HRE*, HRL*, HRM*, HRR*, HRK*
Plastic 2 hardness test
Preliminary test force
Total test
force
N 98.07 588.4
(kgf) 10 60
Scale α-p
Indent depth Brinell hardness test
Preliminary test force Total test force
N
98.07 612.9 1839
(kgf) 10 62.5 187.5
Scale HBT2.5/62.5, HBT2.5/187.5
Test force loading
method
Electric drive motor (load, retain, unload)
Test force control Automatic (load, retain, unload)
Test force load
time
Preliminary test force from 1 through 2 seconds, total test force from 2 through
10 seconds (variable settings in 1-second increments)
Test force reten-
tion time
Preliminary test force from 1 through 120 seconds, total test force from 1 through
120 seconds, preliminary test force (after unloading) from 1 through 120 seconds
(variable settings in 1-second increments)
Test force unload
time
From 1 through 10 seconds (variable settings in 1-second increments)
Test force switch-
ing
Operation using display unit (touch panel)
Main unit electri-
cal power con-
sumption
30 W