v
No. 99MBG518A
■General safety precautions
Do not use the product in areas where volatile gases may be released.
Thesegasesmaycatchre.
Besuretoturnothepowersupplywhileperformingwiringormaintenance.
Otherwise, during work the product could start running unintentionally, causing an accident or electric shock.
This product is a class I device, so be sure to provide protective grounding.
Otherwise, it could cause electric shock or product damage.
Forinformationaboutthepowersourceorelectricalwork,contactalicensedelectricianorotherqualiedindi-
vidual.
Properly ground the power line that is connected to the main body of this product. When connecting to other
instruments, be sure that all the instruments are properly grounded at the power supply with a complete ground
terminal, and then connect the signal cables between them.
Otherwise, it could cause electric shock or product damage.
Use only the power cable that is supplied with this product.
Otherwise, it could cause electric shock or product damage.
If there is a problem with the power cable or the power connector, contact Mitutoyo. Repairs such as part re-
placementshouldbeperformedonlybyaqualiedMitutoyoserviceengineer.
Place the specimen on the stage gently. Do not forcefully strike the specimen stage.
Striking the specimen stage could cause an injury or an accident due to breakage of the part.
For personal protective equipment, wear the following items. Also, for other clothing, refer to the Instruction
Manual.
• Helmet
• Safety shoes
• Protective eyewear
• Protective gloves
• Long sleeves
To Next Page
Loading...
