MI-42-0001 Rev. 19 163
MAINTENANCE: Daily Gain Calibration
5. Select the listed series, and touch
Next
.
6.
Using the
Scroll
tool, step through the slices in the 3D image with an up/down motion on
the Pendant touchscreen.
For information on changing window/level, pan position, zoom, or other DICOM Viewer
settings, see sections 6.8.19 Summary of 3D Image Controls through 6.8.23 Setting Slice
Thickness.
7.
If artifacts similar to those shown in Figure 133 and Figure 134 appear in the image
assessment scan results, contact your distributor or Mobius Imaging Technical Support.
See section 1.2 Contact Data.
Steps
To Next Page
Loading...