Mold-Masters E-Multi EM1 - Page 8

List of Figures
Figure 3-1 Injection molding machine hazard areas ................................................. 3-2
Figure 3-2 E-Multi controller safety hazards ...........................................................3-14
Figure 3-3 E-Multi injection unit safety labels .........................................................3-15
Figure 3-4 Guards layout ........................................................................................3-19
Figure 3-5 Correct side of crate to open .................................................................3-21
Figure 3-6 Remove top row of screws ....................................................................3-21
Figure 3-7 Remove cross brace screws .................................................................3-22
Figure 3-8 Remove screws from side and bottom ..................................................3-22
Figure 3-9 Eyebolts and washers ...........................................................................3-23
Figure 3-10 Install eyebolts and washers ...............................................................3-24
Figure 3-11 Attach slings to all four eyebolts ..........................................................3-24
Figure 3-12 Do not use the motor as a lifting point ................................................. 3-25
Figure 4-1 Controller front ........................................................................................4-1
Figure 4-2 Controller back connections ....................................................................4-2
Figure 4-3 Diagnostic kit (option) .............................................................................. 4-2
Figure 4-4 Cable holders ..........................................................................................4-3
Figure 4-5 Attach cable holders ................................................................................4-3
Figure 5-1 EM3 servo cable routing .........................................................................5-2
Figure 5-2 Robot jumper plug ...................................................................................5-2
Figure 5-3 E-Multi connection locations ...................................................................5-3
Figure 5-4 Handheld HMI and connection ................................................................5-4
Figure 5-5 Wireless network icon .............................................................................5-5
Figure 6-1 E-Multi main power switch ......................................................................6-1
Figure 6-2 Button strip below controller display (HMI) .............................................. 6-2
Figure 7-1 Cabinet mounted control buttons ............................................................7-2
Figure 7-2 Print functionality screen .........................................................................7-7
Figure 7-3 Overview screen .....................................................................................7-9
Figure 7-4 Injection settings screen ........................................................................ 7-13
Figure 7-5 Hold settings screen .............................................................................. 7-16
Figure 7-6 Recovery settings screen ......................................................................7-18
Figure 7-7 Legacy style barrel temperature settings screen ..................................7-21
Figure 7-8 Mold-Masters barrel temperature settings
screen ...............................................................................................................7-23
Figure 7-9 Integrated hot runner controller overview
screen ...............................................................................................................7-26
Figure 7-10 Hot runner controller monitor screen ................................................... 7-27
Figure 7-11 Setup screen (supervisor level) ...........................................................7-31
Figure 7-12 Utilities screen (supervisor level) ........................................................7-35
Figure 7-13 E-Drive control screen components ....................................................7-37
Figure 7-14 E-Drive controller overview screen .....................................................7-39
Figure 7-15 E-Drive setting screen .........................................................................7-41
Figure 7-16 Valve gate settings screen ..................................................................7-43
Figure 7-17 Production graph screen ....................................................................7-45
Figure 7-18 Production graph screen lower menu buttons ..................................... 7-47
Figure 7-19 Process data protocol screen .............................................................. 7-51
Figure 7-20 Process data screen lower menu buttons ...........................................7-52
Figure 7-21 Main setting screen .............................................................................7-53
Figure 7-22 Machine specication screen icons ..................................................... 7-54
Figure 7-23 System settings screen .......................................................................7-55
vii
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
E-Multi Controller User Manual