What should I do if there is a Triac fault on my Mold-Masters E-Multi EM1 Controller?
If there is a Triac fault on your Mold-Masters Controller, check the current output on the channel. If the triac has failed, return the unit to Mold-Masters for repair.
Details common safety hazards associated with injection molding equipment.
Lists potential hazards during the operation of the equipment.
Emphasizes procedures for safely locking out energy sources during maintenance.
Highlights specific safety hazards related to the E-Multi controller.
Details potential hazards associated with the E-Multi injection unit.
Details the cable connections between the controller and E-Multi.
Guides on connecting the controller to the molding machine.
Describes how to safely isolate the controller from the power supply.
Describes the layout and main areas of the touchscreen interface.
Details how to adjust screw movement and transition points.
Explains how to adjust hold pressure settings.
Central access point for configuration, service, and maintenance screens.
Adjusts PID parameters for various control loops.
Lists triggered alarms, their status, time, and description.
Lists and explains fault and warning messages.
General| Temperature Control Zones | 1 |
|---|---|
| Power Supply | 24 VDC |
| Protection Class | IP20 |
| Control Type | PID |
| Display | LCD |
| Communication Interface | RS-485 |
To Next Page
