NICE1000
new
User Manual Description of Function Codes
- 109 -
•
1: Distance control
This method is used in the NICE series integrated elevator controller. During inspection,
the elevator runs at the speed set in F3-11 (Inspection speed). During normal running, the
controller automatically calculates the speed and running curve for the elevator based on
the distance between the current oor and the target oor within the rated elevator speed,
implementing direct travel ride.
Function Code Parameter Name Setting Range Default Unit Property
F0-02
Running speed under
operation panel control
0.050 to F0-04 0.050 m/s
☆
It is used to set the running speed in the operation panel control mode.
Note that this function is enabled only when F0-01 is set to 0 (Operation panel control). You
can change the running speed of the elevator by modifying this parameter during running
Function Code Parameter Name Setting Range Default Unit Property
F0-03 Maximum running speed 0.200 to F0-04 0.480 m/s
★
It is used to set the actual maximum running speed of the elevator. The value must be
smaller than the rated elevator speed.
Function Code Parameter Name Setting Range Default Unit Property
F0-04 Rated elevator speed
0.200–1.750 0.500 m/s ★
It is used to set the norminal rated speed of the elevator. The value of this parameter is
dependent on the elevator mechanism and traction motor.
F0-03 is the actual running speed within the elevator speed range set in F0-04. For example, for a
certain elevator, if F0-04 is 1.750 m/s and the actually required maximum running speed is 1.600
m/s, set F0-03 to 1.600 m/s.
Function Code Parameter Name Setting Range Default Unit Property
F0-05 Maximum frequency F1-04 to 99.00 50.00
Hz ★
It is used to set the maximum output frequency of the system. This value must be larger
than the rated motor frequency.
Function Code Parameter Name Setting Range Default Unit Property
F0-06 Carrier frequency 0.5–16.0 6.0
kHz ★
It is used to set the carrier frequency of the controller.
The carrier frequency is closely related to the motor noise during running. When it is
generally set above 6 kHz, mute running is achieved. It is recommended to set the carrier
frequency to the lowest within the allowable noise, which reduces the controller loss and
radio frequency interference.
•
If the carrier frequency is low, output current has high harmonics, and the power loss and