- 1 -
Preface
Thank you for purchasing the NICE1000
new
integrated elevator controller.
The NICE1000
new
is a new-generation integrated elevator controller independently
developed and manufacturered by Suzhou MONARCH Control Technology Co., Ltd., by
optimizing the NICE1000 controller based on a large number of applications and combining
new industrial features.
The NICE1000
new
has the following advantages:
1. It supports high-performance vector control and open-loop low speed running. It can
drive both AC asynchronous motor and permanent magnetic synchronous motor
(PMSM), and implement switchover between the two types of motors easily by modifying
only one parameter.
2. It supports open-loop low-speed running, direct parallel control of two elevators, and
CANbus and Modbus communication protocols for remote monitoring.
3. It supports a maximum of 16 oors and is widely applied to elevators used in the villa
and freight elevators.
This manual describes the correct use of the NICE1000
new
, including product features,
safety information and precautions, installation, parameter setting, commissioning, and
maintenance & inspection. Read and understand the manual before using the product, and
keep it carefully for reference to future maintenance.
The personnel who involve in system installation, commissioning, and maintenance must
receive necessary safety and use training, understand this manual thoroughly, and have
related experience before performing operations.
Notes
•
The drawings in the manual are sometimes shown without covers or protective guards.
Remember to install the covers or protective guards as specied rst, and then perform
operations in accordance with the instructions.
•
The drawings in the manual are shown for description only and may not match the product
you purchased.
•
The instructions are subject to change, without notice, due to product upgrade, specication
modication as well as efforts to increase the accuracy and convenience of the manual.
•
Contact our agents or customer service center if you need a new user manual or have
problems during the use.
•
Email: UM@inovance.cn