Monarch NICE1000 - Selection of the MCTC-PG Card Models; Terminal Wiring and Description

Mechanical and Electrical Installation NICE1000
new
User Manual
- 42 -
Table 3-6 Selection of the MCTC-PG card models
Encoder Type Adaptable PG Card Appearance
Push-pull encoder
Open-collector incremental
encoder
MCTC-PG-A2
12V
PGM
PGA
PGB
MCTC-PG-A2
J1
CN1
UVW encoder MCTC-PG-D
J1
MCTC-PG-D
CN1
D2
D5
D8
D11
D14
M AI
CN2
SIN/COS encoder MCTC-PG-E
J1
MCTC-PG-E
CN1
Absolute encoder
(ECN413/1313)
MCTC-PG-F1
J1
MCTC-PG-F1
CN1
2. Terminal wiring and description
The MCTC-PG card is connected to the controller and the encoder as follows:
The J1 terminal and CN1 terminal of the MCTC-PG card are respectively connected to the
J12 terminal of the MCB on the controller and the encoder of the motor.
Different MCTC-PG card models are connected to the MCB in the same way. The
connection method to the encoder depends on the CN1 terminal of the model.
The following gure shows the wiring between MCTC-PG-E and the controller.