Monarch NICE1000 User Manual

Description of Function Codes NICE1000
new
User Manual
- 108 -
Chapter 7 Description of Function Codes
The modication property of the parameters includes three types, described as follows:
"
☆
": The parameter can be modied when the controller is in either stop or running state.
"
★
": The parameter cannot be modied when the controller is in the running state.
"●": The parameter is the actually measured value and cannot be modied.
The system automatically restricts the modification property of all parameters to prevent
mal-function.
Group F0: Basic Parameters
Function
Code
Parameter
Name
Setting Range Default Unit Property
F0-00
Control
mode
•
0: Sensorless vector control
(SVC)
•
1: Closed-loop vector control
(CLVC)
•
2: Voltage/Frequency (V/F)
control
1 -
★
It is used to set the control mode of the system.
•
0: Sensorless vector control (SVC)
It is applicable to low-speed running during no-load commissioning of the asynchronous
motor, fault judgment at inspection, and synchronous motor running on special conditions.
•
1: Closed-loop vector control (CLVC)
It is applicable to normal running in distance control.
•
2: Voltage/Frequency (V/F) control
It is applicable to equipment detection where the ratio between the voltage and the
frequency is xed, control is simple, and the low-frequency output torque feature is poor.
Function
Code
Parameter Name Setting Range Default Unit Property
F0-01
Command source
selection
0: Operation panel control
1: Distance control
1 - ★
It is used to set the source of running commands and running speed references.
•
0: Operation panel control
The controller is operated by pressing
RUN
and
STOP
RES
on the operation panel, and
the running speed is set by F0-02 (Running speed under operation panel control). This
method is applicable only to the test or motor no-load auto-tuning.

Monarch NICE1000 Specifications

General

Brand	Monarch
Model	NICE1000
Category	Controller
Language	English