EasyManuals Logo

Monarch NICE1000 User Manual

Monarch NICE1000
205 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #168 background imageLoading...
Page #168 background image
Description of Function Codes NICE1000
new
User Manual
- 166 -
Function Code Parameter Name Setting Range Default Unit Property
Fd-03
Number of elevators in
parallel control mode
1–2 1 -
Fd-04 Elevator No. 1–2 1 -
These two parameters are used to set the quantity and No. of the elevators in parallel
control mode.
Function Code Parameter Name Setting Range Default Unit Property
Fd-05
Parallel control function
selection
Bit0: Dispersed waiting 1 -
When Bit0 = 1, the elevator does not return to the base oor; one elevator waits at the base
oor and the other waits at a non-base oor.
Group FE: Elevator Function Parameters
Function Code Parameter Name Setting Range Default Unit Property
FE-00 Collective selective mode 0–2 0 -
It is used to set the collective selective mode of the system.
The values are as follows:
0: Full collective selective
The elevator responds to both up and down hall calls.
1: Down collective selective
The elevator responds to down hall calls but does not respond to up hall calls.
2: Up collective selective
The elevator responds to hall up calls but does not respond to hall down calls.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Monarch NICE1000 and is the answer not in the manual?

Monarch NICE1000 Specifications

General IconGeneral
BrandMonarch
ModelNICE1000
CategoryController
LanguageEnglish

Related product manuals