- 138 -
Function Code Parameter Name Setting Range Default Unit Property
F6-61 Leveling sensor delay 10–50 14 ms
★
It is used to set the delay time from the action time of the leveling sensor to the time when
the leveling signal becomes active. You need not modify this parameter.
Function Code Parameter Name Setting Range Default Unit Property
F6-62
Time interval of random
running
0–1000 3 s
☆
It is used to set the time interval between two times of random running.
Function Code Parameter Name Setting Range Default Unit Property
F6-64
Program control
selection 1
0–65535 0 -
★
F6-65
Program control
selection 2
0–65535 0 -
★
F6-66
Program control
selection 3
0–65535 0 -
★
These parameters are used to set program control functions.
Each bit of the function code denes a function, as described in the following table.
If a bit is set to 1, the function indicated by this bit is enabled; if this bit is set to 0, the
function is disabled.
For details on how to view and set this function code in bit, refer to F6-06.
Table 7-9 Functions indicated by the bits of F6-64
F6-64 Program control selection 1
Bit Function Description Default
Bit1 Soft limit function
When the up slow-down and down leveling signals are
active and the up leveling signal is inactive, the system
considers that the up limit is performed. It is the same for
the down limit signal.
0
Bit4
Opening only one
door of opposite
doors under
manual control
This function is enabled only in the opposite door control
mode 3 (hall call independent, opposite-door manual
control). In this case, only one door opens each time while
the other door must stay in the door close limit state.
0
Bit5
Clearing calls
immediately at
elevator lock
When the elevator lock signal is active, the system
immediately clears the registered calls and enables the
elevator to stop at nearest landing oor and then return to
the elevator lock oor.
0
Bit9
Disabling reverse
oor number clear
The system clears all the current car calls by default
every time the elevator changes the direction. When this
function is enabled, the function of clearing reverse oor
numbers is disabled.
0
Bit11
Responding to car
calls rst
The system responds to hall calls only after executing all
car calls.
0