4-132 Motorola RF Switch System Reference Guide
4.8.1.1 Editing Default Access Port Adoption Settings
Use the Edit screen to dedicate a target radio as a detector radio, as well as change the radios settings
(placement, power, and channel) and advanced properties (antenna setting, maximum associations, adoption
preference, etc.).
To edit radio adoption configuration settings:
1. Select Network Setup > Access Port Adoption Defaults from the main menu tree.
2. Click the Configuration tab.
3. Select a radio from the table.
CAUTION: An Access Port is required to have a DHCP provided IP address before
attempting layer 3 adoption, otherwise it will not work. Additionally, the Access Port must
be able to find the IP addresses of the switches on the network.
To locate switch IP addresses on the network:
• Configure DHCP option 189 to specify each switch IP address.
• Configure a DNS Server to resolve an existing name into the IP of the switch. The Access
Port has to get DNS server information as part of its DHCP information. The default DNS
name requested by an AP300 is “Symbol-CAPWAP-Address”. However, since the default
name is configurable, it can be set as a factory default to whatever value is needed.
To Next Page
Loading...
Need help?
General
