Motorola RFS Series System Reference Guide

3-24 Motorola RF Switch System Reference
3.2.6 Configuring WAN Interface Cards
The RFS6000 switch supports 3G Wireless WAN cards using the ExpressCard slot. In order to use a 3G
Wireless WAN card with the switch, it must first be initialized on a laptop. For activation and initialization
information, refer to the instructions included with the card. If your Wireless WAN Interface card service
provider makes use of a PIN number for access to the network, disable the PIN number before using the card
with the switch.
To configure a Wireless WAN Interface card:
1. Select Switch > Ports from the main menu tree.
2. Select the Wireless WAN Interface Card tab.
3. Enter the following parameters to configure a WAN Interface Card:.
Access Port Name If your Wireless WAN service provider requires you to specify an Access Port
Name, enter that value here. The range is <0-25> and default value is 0
User Name Enter the User Name configured for use with the Wireless WAN Interface Card.
The string range is <0-32> and default value is 0
Password Enter the Password associated with the above User Name for the Wireless WAN
Interface Card.The string range is <0-30> and default value is 0
Activation Mode Select Enable from the pull-down menu to enable the Wireless WAN Interface
Card. Select Disable from the pull-down menu to turn off the Wireless WAN
Interface Card.
Preferred DNS
Server
Displays the primary/preferred DNS Server provided by the Wireless WAN service
provider.
Alternate DNS
Server
Displays the secondary/alternate DNS Server provided by the Wireless WAN
service provider.

Motorola RFS Series Specifications

General

Brand	Motorola
Model	RFS Series
Category	Switch
Language	English