6-28 Motorola RF Switch System Reference Guide
5. Select an interface and click on Edit to modify the LAN Index, IP ACL and MAC ACL values. For more
information see,Editing an Adaptive AP LAN on page 6-28.
6.4.6.1 Editing an Adaptive AP LAN
To Edit an AAP LANs page:
1. Select Security > Wireless Firewall from the main menu tree.
2. Click on the Security Policy tab.
3. Click on the Wireless Filters tab.
4. On the Attach AAP WLAN tab select a WLAN and click the Edit button:
5. Refer to the Status field for the state of the requests made from applet. This field displays error
messages if something goes wrong in the transaction between the applet and the switch.
6. Click OK to use the changes to the running configuration and close the dialog.
7. Click Cancel to close the dialog without committing updates to the running configuration.
6.4.7 Configuring Wireless Filters
Use filters to either allow or deny a MAC address (or groups of MAC addresses) from associating with the
switch. Refer to the Wireless Filters screen to review the properties of existing switch filters. A filter can
be selected from those available and edited or deleted. Additionally, a new filter can be added if an existing
filter does not adequately express the MU’s address range required.
To display the Wireless Filters main page:
1. Select Security > Wireless Firewall from the main menu tree.
2. Click on the Security Policy tab.
3. Click on the Wireless Filters tab.
AP MAC Address Displays the MAC Address of the selected Adaptive AP. This value cannot be
modified.
LAN Index The LAN Index displays the list of attached Adaptive AP LANs with ACLs.
ACL ID: Inbound Edit the Inbound ACL ID for the selected Adaptive AP.
ACL ID: Outbound Edit the Outbound ACL ID for the selected Adaptive AP.
To Next Page
Loading...
Need help?
General
