Switch Management
This chapter describes the Management Access main menu items used to configure the switch. This chapter
consists of the following switch management activities:
• Displaying the Management Access Interface
• Configuring Access Control
• Configuring SNMP Access
• Message Parameters
• Configuring SNMP Trap Receivers
• Configuring Management Users
7.1 Displaying the Management Access Interface
Refer to the main Management Access interface for a high-level overview of the current switch firmware
version and the current switch log output configuration. Use this information to discern whether a switch
firmware upgrade is required (by checking the Website for a newer version) and if the switch is outputting
log data appropriately.
NOTE: HTTPS must be enabled to access the switch applet. Ensure HTTPS access has
been enabled before using the login screen to access the switch applet.
NOTE: When the switch’s configuration is successfully updated (using the Web UI), the
effected screen is closed without informing the user their change was successful.
However, if an error were to occur, the error displays within the effected screen’s Status
field and the screen remains displayed. In the case of file transfer operations, the transfer
screen remains open during the transfer operation and remains open upon completion
(with status displayed within the Status field).
To Next Page
Loading...
