Motorola RFS Series - Configuring SOLE Parameters

5-66 Motorola RF Switch System Reference
5.8.3.1 Adding AP Location Information
1. To add AP Location information for your site: Select Services > RTLS from the main menu tree.
2. Select the Site tab.
3. Click the Add button.
5.8.4 Configuring SOLE Parameters
To configure the switch’s internal SOLE locationing engine:
1. .Services > RTLS from the main menu tree.
2. Select the SOLE tab.
3. Check the Locate All Mobile-Units checkbox to locate all MUs known to the switch across all WLANs.
This will also disable manual entry of MU MAC addresses in the field below.
This takes effect immediately when the box is checked.
4. Enter a value for the MU Locate Interval in seconds. The MU Locate Interval determines how often
the locationing of MUs is updated. The valid range for this is between 5 to 3600 seconds.
5. Click the Apply button to save the MU Locate Interval value.