Motorola RFS Series System Reference Guide

Switch Services 5-65
width of the site is then mapped out on the X and Y axes. Those length and width along with the height
are entered into the field below.
Define the Dimensions and Unit of measure used to define the site size:
5. The AP Information section displays the following information about APs:
6. Click the Apply button to save the changes made within this screen. Clicking Apply overwrites the
previous configuration.
7. Click the Revert button to disregard any changes made within this screen and revert back to the last
saved configuration.
Length Enter the length of the site. This is the X axis of your site map based on the origin
point of 0,0. The size is either in feet or meters depending on which unit of
measure is selected below. The valid range for length is 1-1000m or 1-3000ft.
Width Enter the width of the site. This is the Y axis of your site map based on the origin
point of 0,0. The size is either in feet or meters depending on which unit of
measure is selected below. The valid range for width is 1-1000m or 1-3000ft.
Height Enter the height of the site. The size is either in feet or meters depending on which
unit of measure is selected below. The acceptable range for height is 0-20m or 0-
60ft. Height is an optional parameter and is not taken into account by the
locationing algorithm.
Unit Use the pull-down menu to select the unit of measure used for dimensions. The
options are feet or meters.
AP MAC Lists the MAC Addresses of all APs which have been configured for RTLS.
Location:
X Coordinate
Displays the value of the X Coordinate for each AP. The X coordinate is relative to
the origin point of 0,0 in the upper left corner of the site map. This value is user
configured and not detected by the switch. For information on how to configure AP
location information, see Chapter 5.8.3.1, Adding AP Location Information.
Location:
Y Coordinate
Displays the value of the Y Coordinate for each AP. The Y coordinate is relative to
the origin point of 0,0 in the upper left corner of the site map. This value is user
configured and not detected by the switch. For information on how to configure AP
location information, see Chapter 5.8.3.1, Adding AP Location Information.
Location:
Z Coordinate
Displays the value of the Z Coordinate for each AP. The Z coordinate is the height
of the AP relative to the lowest point of the site. This value is user configured and
not detected by the switch. For information on how to configure AP location
information, see Chapter 5.8.3.1, Adding AP Location Information.
Status Displays the status value for each AP.
Switch IP Displays the IP address of switch associated with each AP configured for RTLS.
11a Radio Displays the Index, MAC Address, Power and Channel information for the 802.11a
radio on each AP.
11b Radio Displays the Index, MAC Address, Power and Channel information for the 802.11b
radio on each AP.

Motorola RFS Series Specifications

General

Brand	Motorola
Model	RFS Series
Category	Switch
Language	English