Switch Web UI Access and Image Upgrades
cluster cfg yes ftp://ftp:ftp@192.9.200.1/RFSwitch/cluster-config
image yes ftp://ftp:ftp@147.11.1.11/RFSwitch/images/RFS6000.img
expected image version
4.3.0.0-XXXXX
Once again, for DHCP option based auto install the URLs is ignored and those passed by DHCP are not stored.
Whenever a string is blank it is shown as --not-set--.
2.4 AP-4131 Access Point to Access Port Conversion
To convert an AP-4131 “fat” Access Point to a “thin” AP-4131 Access Port you need to load the port
conversion version firmware. Refer to the files available with you Motorola Web site download package.
To convert an AP-4131 Access Point
1. Verify a TFTP server is up and running and the firmware you are going to install is in the root directory of
the TFTP server.
2. Log in to the AP-4131 as Admin. The default password is Motorola.
3. Select the AP Installation main menu item.
4. From the IP Address field, enter a new IP address (if required) and select Save-[F1] to save the change.
If the IP address was changed, you will need to reset the AP for the change to be implemented.
SWITCH NOTE: AP-4131 Access Point to Access Port Conversion is only available on the
RFS6000 platform.
To Next Page
Loading...
