5-58 Motorola RF Switch System Reference
3. Select an existing profile and click the Edit button to modify the profile name starting and ending IP
address and SNMP version. Motorola recommends editing a profile only if some of its attributes are still
valid, if the profile is obsolete, delete it and create a new one.
4. Select an existing profile and click the Delete button to remove this profile from the list of available
profiles.
5. Click the Add button to display a screen used to define a new switch discovery profile. For more
information, see Adding a New Discovery Profile on page 5-59.
6. Click the Start Discovery button to display a Read Community String (SNMP v2) or V3
Authentication (SNMP v3) screen.
compromise switch security. Therefore, when Start Discovery is selected, the switch prompts the user to
verify their SNMP credentials against the SNMP credentials of discovered devices. SNMP v2 and v3
credentials must be verified before the switch displays discovered devices within the Recently Found
Devices table.
If SNMP v2 is used with a discovering profile, a Read Community String screen displays.The
Community String entered is required to match the name used by the remote network management
software of the discovered switch.
If SNMP v3 is used with a discovering profile, a V3 Authentication screen displays. The User Name and
Password are required to match the name used by the remote network management software of the
discovered switch.
When the credentials of the V2 Read Community or V3 Authentication screens are satisfied, the switch
discovery process begins.
7. If necessary, click the Stop Discovery button (enabled only during the discovery operation) to stop the
discovery operation.
To Next Page
Loading...
Need help?
General
