Switch Services 5-69
4. Enter the Multicast MAC Address used for all Aeroscout tags to send updates via multicast to the
MAC address specified. Typically the MAC address will start with 01-0C-CC-XX-XX-XX.
5. Click the Apply button to save the Multicast MAC Address value.
6. Click the Revert button to cancel any changes made within Multicast MAC Address value and revert
back to the last saved configuration.
7. If the Multicast MAC Address is configured and Aeroscout support is enabled the following
information will be displayed:
8. To use the onboard SOLE engine to locate Aeroscout tags check the Enable checkbox. This is enabled
immediately after checking the box.
9. If the onboard SOLE engine is enabled to locate Aeroscout tags, enter a Locate Interval in seconds to
specify how often the known tags are located by the SOLE engine.
10.Click the Apply button to save the Locate Interval value.
11.Click the Revert button to cancel any changes made within Locate Interval value and revert back to
the last saved configuration.
NOTE: To use the onboard SOLE engine to locate Aeroscout tags, site parameters, AP
location (Command Line Interface only) and Zone configuration (optional, Command Line
Interface only) must be configured.
IP Address Displays the IP address of the external Aeroscout RTLS engine.
Port Displays the port number which the switch uses to connect to the external
Aeroscout RTLS engine.
No. of RX Msgs Displays the number of messages received by the switch from the external
Aeroscout RTLS engine.
Last Msg RX Time Displays the Date and Time that the last message was received from the external
Aeroscout RTLS engine.
No. of TX Msgs Displays the number of messages transmitted by the switch to the external
Aeroscout RTLS engine.
Last Msg TX Time Displays the Date and Time that the last message was sent to the external
Aeroscout RTLS engine.
No. of Tag Reports Displays the number of Tag Reports received from the external Aeroscout RTLS
engine.
To Next Page
Loading...
Need help?
General
