Switch Security 6-121
5. Use the Scan Time value to enter the duration of the scan. The radio scans each channel for the defined
interval. The default value is 100 milliseconds.
6. Define a Max Number of APs value to set the number of detected APs displayed in the Beacon Found
table. The available range is from 0 to 512.
7. Refer to 802.11a Channel Set field to select channels for the 802.11a transmission band. The channel
information is provided to the switch, which then makes an 802.11a radio scan for the configured
channels.
8. Refer to 802.11bg Channel Set field to select channels for the 802.11bg transmission band. The channel
information is provided to the switch, which conducts an 802.11bg scan for each channel.
Allowed Displays the channels available to the AP. The channel list is country specific and
differs from country to country.
Add -> Select a channel frequency and click the Add -> button to include the channel to
the Configured list box. You can select multiple channels and add them to the
Configured list box. Press the Ctrl button and use the mouse to select multiple
channels. The switch uses an 802.11a radio to scan the selected channels to
detect any rogue AP’s.
<- Remove Select the channel’s frequency from the Configured list box and click <- Remove
to remove a channel from the list of channels provided to the switch.
Configured Displays the channels provided to the switch. The switch makes all the 802.11a
radios move to the selected channel and scan (one at a time), for a configurable
interval.
Enable all Select the Enable all button (within the 802.11a Radios field) to enable all
802.11a radios from receive beacons.
Disable all Select the Disable all button (within the 802.11a Radios field) to disable all
802.11a radios from receiving beacons.
Allowed Displays all the channels available to the AP. The channel list is country specific
and differs from country to country.
Add -> Select a channel frequency and click the Add -> button to include the channel to
the Configured list box. Select multiple channels and add them to the
Configured list box. Press the Ctrl button and use the mouse to select multiple
channels. The switch uses an 802.11a radio to scan the selected channels to
detect any non-adopted or rogue AP’s.
<- Remove Select the channel’s frequency from the Configured list box and click <- Remove
to remove a channel from the list of channels provided to the switch.
Configured Displays the channels provided to the switch. The switch makes all the 802.11bg
radios move to a channel from this channel-set and scan these channels, one at a
time, for a configurable duration.
Enable all Select the Enable button (within the 802.11bg Radios field) to enable all the
802.11bg radios receive enhanced beacons.
Disable all Select the Disable button (within the 802.11bg Radios field) to disable all the
802.11bg radios from receiving enhanced beacons.
To Next Page
Loading...
Need help?
General
