Switch Management 7-7
based Access Control Model (VACM) for access control. The architecture supports the concurrent use of
different security, access control, and message processing techniques.
Refer to the v3 screen to review the current SNMP v3 configuration. An Existing User Name can be selected
and edited, enabled or disabled. .
To review existing SNMP v3 definitions:
1. Select Management Access > SNMP Access from the main menu tree.
2. Select the V3 tab from within the SNMP Access screen.
3. Refer to the fields within the V3 screen for the following information:
NOTE: The SNMP undo feature is not supported in this product.
User Name Displays a read-only SNMP v3 username of operator or Admin. An operator
typically has an Access Control of read-only and an Admin typically has an Access
Control of read/write.The username string length is <0-3>.
Access Control Displays a read-only (R) access or read/write (RW) access for the v3 user. Read-only
access allows the user (when active) to retrieve information, while read/write
access grants the user modification privileges.
Authentication Displays the current authorization scheme used by this user for v3 access to the
switch. Click the Edit button to modify the password required to change
authentication keys.
Encryption Displays the current Encryption Standard (DES) protocol the user must satisfy for
SNMP v3 access to the switch. Click the Edit button to modify the password
required to change encryption keys.
Status Displays whether this specific SNMP v3 User Name is active on the switch. For
more information, see Accessing SNMP v2/v3 Statistics on page 7-8.
To Next Page
Loading...
Need help?
General
