7-20 Motorola RF Switch System Reference Guide
2. Click the Add button at the bottom of the screen.
3. Create a new (non DNS name) destination IP address for the new trap receiver to be used for receiving
the traps sent by the SNMP agent.
4. Define a Port Number for the trap receiver.
5. Use the Protocol Options drop-down menu to specify the trap receiver as either a SNMP v2c or v3
receiver.
6. Click OK to save and add the changes to the running configuration and close the dialog.
7. Refer to the Status field for the current state of the requests made from applet. This field displays error
messages if something goes wrong in the transaction between the applet and the switch.
8. Click Cancel to close the dialog without committing updates to the running configuration.
To Next Page
Loading...
