Motorola RFS Series System Reference Guide

Switch Information 3-39
3. Refer to the Redundancy Configuration field to enable and define the configuration for automatic
cluster file updates.
4. Refer to the Firmware field to enable and define the configuration for automatic firmware updates. If
enabled, the located (updated) switch firmware is used with the switch the next time the switch boots.
Protocol Use the Protocol drop-down menu to specify the FTP, TFTP, HTTP, SFTP, or
resident switch FLASH medium used for the file update from the server. FLASH is
the default setting.
Password Enter the password required to access the server.
SWITCH NOTE: In addition to the Protocols listed on the RFS7000, users can also auto-
update using USB or Compact Flash. On the RFS6000, users can also auto-update using
USB.
Enable Select the Enable checkbox to allow an automatic cluster file update when a new
(updated) file is detected (upon the boot of the switch) at the specified IP address.
IP Address Define the IP address of the server where the cluster files reside. If a new version
is detected when the switch is booted, it will be uploaded to the switch and used
upon the next boot of the switch.
User ID Enter the User ID required to access the FTP or TFTP server.
File Name (With
Path)
Provide the complete and accurate path to the location of the cluster files on the
server. This path must be accurate to ensure that the most recent file is retrieved.
Protocol Use the Protocol drop-down menu to specify the FTP, TFTP, HTTP, SFTP, or
resident switch FLASH medium used for the file update from the server. FLASH is
the default setting.
Password Enter the password required to access the server.
Enable Select the Enable checkbox to allow an automatic firmware update when a new
(updated) version is detected (upon the boot of the switch) at the specified IP
address.
IP Address Define the IP address of the server where the firmware files reside. If a new
version is detected when the switch is booted, it will be uploaded to the switch
and used upon the next boot of the switch.
User ID Enter the User ID required to access the FTP or TFTP server.
File Name (With
Path)
Provide the complete and accurate path to the location of the firmware files on the
server. This path must be accurate to ensure that the file is retrieved.
Protocol Use the Protocol drop-down menu to specify the FTP, TFTP, HTTP, SFTP, or
resident switch FLASH medium used for the file update from the server. FLASH is
the default setting.
Password Enter the password required to access the server.
Version Provide the target firmware version to ensure that the switch is upgrading to the
intended baseline.

Motorola RFS Series Specifications

General

Brand	Motorola
Model	RFS Series
Category	Switch
Language	English