3. Check that the AUX button is active on the left of the Mixer — if not, click it to enable it
and display the settings for the auxiliary outputs of each channel strip.
4. Navigate to the channel of which you want to configure an auxiliary output: for a Sound
click the header of its parent Group (or double-click it if the Mixer currently displays the
Group channel strips), and for a Group simply ensure that its channel strip is visible (dou-
ble-click the Group header if the Mixer currently displays the Sound channel strips).
5. In the channel strip of the desired Sound or Group, click the AUX 1 or AUX 2 label (de-
fault labels) at the bottom of the strip and select the desired destination in the menu.
This is equivalent to setting the Dest. parameter described above.
Audio Routing, Remote Control, and Macro Controls
Audio Routing in MASCHINE
MASCHINE - Manual - 547
To Next Page
Loading...
