Native Instruments MASCHINE MK3 User Manual

Tape Mode – Parameter Description
MAIN Section
Mode Selects between Classic, Tape, and Tube saturation modes. All
other parameters vary according to the mode selected here.
Input Controls the input gain of the effect. This affects the amount of
tape distortion and compression.
Contour Controls the high frequency roll-off starting frequency.
Frequencies above this point will be attenuated.
Drive Controls the low frequency boost/cut of the effect.
Tube Mode
The Tube mode emulates the smooth saturation of overdriven tube amplifiers. It is equipped
with a feedback-driven dynamic compression and an additional EQ section allowing you to fine
adjust the frequency content to be processed.
The Saturator in Tube mode in the Control area.
Tube Mode – Parameter Description
MAIN Section
Mode Selects between Classic, Tape, and Tube saturation modes. All
other parameters vary according to the mode selected here.
Effect Reference
Distortion Effects
MASCHINE - Manual - 724

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs