Native Instruments MASCHINE MK3 User Manual

Using the EDIT Page on Your Controller
► In Sampling mode, press Button 2 to access the EDIT page.
The EDIT page on the controller.
The right display shows the waveform of the selected Sample:
▪ Turn Knob 5 to zoom in on the waveform of the Sample and Knob 6 to scroll through it.
▪ Above the waveform, the information bar indicates the name and length of the Sample.
▪ The Sample can be played back at any time by pressing the corresponding pad on your
controller. When the Sample is played back, the playhead indicator (vertical line) shows
you the current play position within the waveform on the right display.
The parameters available at the bottom of the left display are spread over two pages.
► Use the Page buttons on the left of the displays to select the desired page.
Page 1 – PLAY RANGE Parameters
The parameters in the PLAY RANGE section allow you to adjust the range that will be played
back when you trigger a note.
Sampling and Sample Mapping
Editing a Sample
MASCHINE - Manual - 827

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs