Virtual Private Networking Using IPSec Connections
256
ProSecure Unified Threat Management (UTM) Appliance
Use the VPN Wizard to Configure the Gateway for a Client Tunnel
To set up a client-to-gateway VPN tunnel using the VPN Wizard:
1. Select VPN > IPSec VPN > VPN Wizard. The VPN Wizard screen displays (see the
following figure, which contains an example for a multiple WAN port model). The WAN
radio drop-down lists are shown on the VPN Wizard screen for the multiple WAN port
models but not on the VPN Wizard screen for the single WAN port models.
Figure 149.
To display the wizard default settings, click the VPN Wizard default values option arrow
in the upper right of the screen. A pop-up screen displays (see Figure 145 on page 253),
showing the wizard default values. After you have completed the wizard, you can modify
these settings for the tunnel policy that you have set up.
To Next Page
Loading...
