NETGEAR UTM5 User Manual

Manually Configuring Internet and WAN Settings
83
ProSecure Unified Threat Management (UTM) Appliance
4. Click Apply to save your settings. The protocol binding rule is added to the Protocol
Bindings table. The rule is automatically enabled, which is indicated by the ! status icon, a
green circle.
 To edit a protocol binding:
1. On the Protocol Bindings screen (see Figure 46 on page 81), in the Protocol Bindings
table, click the Edit table button to the right of the binding that you want to edit. The Edit
Protocol Binding screen displays. This screen shows the same fields as the Add Protocol
Binding screen (see the previous figure).
2. Modify the settings as explained in the previous table.
3. Click Apply to save your settings.
 To enable, disable, or delete one or more protocol bindings:
1. On the Protocol Bindings screen (see Figure 46 on page 81), select the check box to the
left of each protocol binding that you want to enable, disable, or delete, or click the
Select All table button to select all bindings.
2. Click one of the following table buttons:
• Enable. Enables the binding or bindings. The ! status icon changes from a gray circle
to a green circle, indicating that the selected binding or bindings are enabled. (By
default, when a binding is added to the table, it is automatically enabled.)
Source Network The source network settings determine which computers on your network are affected by
this rule. Select one of the following options from the drop-down list:
Any All devices on your LAN.
Single address In the Start IP field, enter the IP address to which the rule is applied.
Address Range In the Start IP field and End IP field, enter the IP addresses for the
range to which the rule is applied.
Group 1–Group 8 If this option is selected, the rule is applied to the devices that are
assigned to the selected group.
Note: You can also assign a customized name to a group (see
Change Group Names in the Network Database on page 109).
Destination
Network
The destination network settings determine which Internet locations (based on their IP
address) are covered by the rule. Select one of the following options from the drop-down
list:
Any All Internet IP address.
Single address In the Start IP field, enter the IP address to which the rule is applied.
Address range In the Start IP field and End IP field, enter the IP addresses for the
range to which the rule is applied.
Table 18. Add Protocol Binding screen settings (continued)
Setting Description

NETGEAR UTM5 Specifications

General

Brand	NETGEAR
Model	UTM5
Category	Firewall
Language	English