M10 AT Commands Set
M10_ATC_V1.01 - 136 -
AT+QEXTUNSOL Enable /Disable Proprietary Unsolicited Indications
Response
+QEXTUNSOL:(list of supported <exunsol>s)
OK
Test Command
AT+QEXTUNS
OL
=?
Parameters
see Write Command
Response
OK
ERROR
Write Command
AT+QEXTUNS
OL=<exunsol> ,<
mode>
Parameters
<exunsol> string type. values currently reserved by the present
document
“SQ”
Signal Quality Report
Displays signal strength and channel bit error rate (similar
To AT+CSQ) in form +CSQN: <rssi>,<ber>when values change.
“FN” forbidden network available only
When returning to a non- registered state this indicates whether
All the available PLMNs are forbidden.
“MW” SMS Message waiting
On receiving an SMS (as indicated by the +CMTI indication) the
SMS is decoded and checked to see if it contains one or more of the
message waiting indications (i.e. voicemail, email, fax etc). If so, an
unsolicited indication is shown in the form for each message type:
+CMWT: <store>,<index>,<voice>,<fax>,<email>,<other>
Where <store> is the message store containing the SM, index is the
message index and <voice>,<email>,<fax>,<other> contain the
number of waiting messages (with ‘0’ defined as clear indication,
non-zero for one or more waiting messages) or blank for not
specified in this message.
“UR” Unsolicited result code
Produces an unsolicited indication following particular call state
Transitions. Multiple notifications may occur for the same transition
+CGURC: <event>
Where <event> describes the current call state:
<event>
0 Active call terminated, at least one held call remaining
1 Attempt to make an Mobile Originated call
2 Mobile Originated Call has failed for some reason
3 Mobile Originated call is ringing
4 Mobile Terminated call is queued (Call waiting)
5 Mobile Originated Call now connected
6 Mobile Originated or Mobile Terminated call has disconnected
7 Mobile Originated or Mobile Terminated call hung up
8
Mobile Originated call to non-emergency number in emergency
To Next Page
Loading...
Need help?
General
