Quectel M10 - Page 163

M10 AT Commands Set
M10_ATC_V1.01 - 162 -
L=”SQ”,1
20 Forbidden network available
only
AT+QEXTUNSO
L=”FN”,1
21 +CMWT:<store>,<index>,<voic
e>,<fax>,<email>,<other>
Messagewaiting AT+QEXTUNSO
L=”MW”,1
22 +CGURC:<event> Unsolicited result code follow
particular call state transition
AT+QEXTUNSO
L=”UR”,1
23 +CBCN<bcs>,<bcl> Display battery connextion
status and battery charge level
AT+QEXTUNSO
L=”BC”,1
24 +QBAND:<band> Band mode display AT+QEXTUNSO
L=”BM”,1
25 +TSMSINFO:<CMS error info> Additional SMS information AT+QEXTUNSO
L=”SM”,1
26 +CCINFO:<Call is
Disconnected>,<remain calls>
Displays the disconnected call
ID and the remain call numbers
after one of the call
disconnected
AT+QEXTUNSO
L=”CC”,1
27 RING Indicates incoming call n/a
28 Call Ready Device ready to make/receive
calls
n/a
29 Charging in NORNAL MODE The module is in charging state n/a
30 From GHOST MODE to
NORMAL MODE
Device is turned on when in
charging state
n/a
31 +QTEMP:-1 Low temperature warning AT+QTEMP=1
32 +QTEMP:1 High temperature warning AT+QTEMP=1
33 +QTEMP:-2 Low temperature shutdown
indicator
AT+QTEMP=1
34 +QTEMP:2 High temperature shutdown
indicator
AT+QTEMP=1
35 UNDER_VOLTAGE POWER
DOWN
Under voltage shutdown
indication
n/a
36 UNDER_VOLTAGE
WARNING
Under voltage warning n/a
37 OVER_VOLTAGE POWER
DOWN
Over voltage shutdown
indication
n/a
38 OVER_VOLTAGE WARNING Over voltage warning n/a
39 UNDER_VOLTAGE POWER
DOWN
Normal power down n/a
40 +COLP:<number>,<type>[,<sub
addr>,<satype>[CLI validity]],
The presentation of the
COL(connected line) at the TE
for a mobile originated call
AT+COLP =1
41 +CLIP:<number>,<type>””,,<al
phaID>,<CLI validity>
Mobile terminating call
indication
AT+CLIP =1
42 +CRING:<type> An incoming call is indicated to AT+CRC=1
Quectel