Troubleshooting
QL-300 User Guide 314
The position that printing starts on
the leading edge is misaligned.
(The first page is misaligned)
The paper and media form that you
are using have been switched.
Do fine adjustments to the print
position.
Set Cut Mode-Specified Inter-
val-Cut Interval to “1”. Then print 5
pages of your content on the media
you are actually using and use
them to measure the differences in
the position you want to print and
the actual printed positions, and
then calculate the average of these
5 measurements.
Use this difference to finely adjust
the print position using the print
position correction (Y position).
(The second and following pages
are misaligned)
Immediately after doing paper
interval detection, replacing the roll
of paper, or changing the print pat-
tern, the print position adjustment
(auto) was not done well enough.
Print 20 continuous pages of the
actual print pattern you are using
(set Cut Mode-Specified Inter-
val-Cut Interval to “20”) so you can
compensate for the position that
printing starts.
Printing extends off the trailing
edge of the paper.
The paper size specified in the
printer driver is different from the
paper size that is loaded.
Specify the correct paper size in
the printer driver.
The compensation value specified
for the print position correction (Y
position) is too large.
Specify a correction value that is
within a range that the printing
does not extend off the trailing
edge of the paper.
If the image extends off the trailing
edge of the paper, clean the 2nd
transfer roller.
Pages are cut on a different page
than the specified page.
Last of the paper was detected. Replace the paper with a new roll
of paper. When reprinting, paper is
output from the page where the
error occurred up to the cut page.
So, if you want to justify the num-
ber of pages up to the cut, tempo-
rarily cancel printing and send print
data starting from the page you
want to reprint.
Symptom Cause Troubleshooting
To Next Page
Loading...
