RADIOMETER ABL90 FLEX - Page 309

ABL90 FLEX reference manual 10. Troubleshooting, updated for software version 2.3
10-41
No. Message Interpretation Operator action
1326 Sensor
thermistor
recalibration
failed -
thermistor mal-
functioning
Shown in the Activity Log
when "User-intervention
required" has been entered
due to this reason.
- The analyzer will
automatically enter
"User-intervention
required". Follow the
instructions shown on
the screen.
1327 Analyzer locked
by user
User has locked the analyzer - No action required.
1328 Analyzer locked
on request from
LIS
The analyzer was locked on
request from LIS
- No action required.
1329 Analyzer locked
on request from
Radiance
The analyzer was locked on
request from Radiance
- No action required.
1330 pO
2
substrate
thickness
The thickness of the pO
2
substrate is outside the
ranges
1331 Intervention
required entered
The analyzer enters UIR - No action required.
1332 Intervention
required exited
The analyzer exits UIR - No action required.
1333 Sensor
conditioning
started, no BC
Sensor conditioning started,
no barcode was scanned
- No action required.
1334 Sensor
conditioning
started, BC
Sensor conditioning started,
a valid barcode was scanned
- No action required.
1335 Solution pack
replaced
This message is used in the
Activity log to indicate
replacement of solution pack
- No action required
1336 Sensor cassette
replaced
This message is used in the
Activity log to indicate
replacement of sensor
cassette
- No action required
1337 Printer paper
replaced
This message is used in the
Activity log to indicate
replacement of printer paper
- No action required
1338 Demo mode
enabled
This message is used in the
Activity log to indicate that
ABL 90 demo mode has been
enabled
- No action required
1339 Demo mode
disabled
This message is used in the
Activity log to indicate that
ABL 90 demo mode has been
disabled
- No action required