RADIOMETER ABL90 FLEX - Page 53

ABL90 FLEX reference manual 1. Setup
1-33
To add a new RiLiBÄK rule, do the following:
Step Action
1. Press the Add button to display the screen below:
2. Select the desired parameter from the parameter list shown in the
right side of the screen.
3.
Press
until the first "Lower Limit" box is highlighted and enter
the desired lower limit.
4. Highlight the next box and select "<" or "<=".
5. Highlight the first "Upper Limit" box and select "<" or "<=".
6. Highlight the next "Upper Limit" box and enter the desired lower
limit.
7. To select the desired +/- range, press the desired radio button.
8. Enter the desired +/- range in the "Ranges" box.
9. Press Back to return to the RiLiBÄK ranges screen. The added
RiLiBÄK rule is now shown in the screen.