R&S FSV3000 Series - Page 480

Common Analysis and Display Functions
R&S
®
FSVA3000/ R&S
®
FSV3000
480User Manual 1178.8520.02 ─ 01
Remote command:
CALCulate<n>:LIMit<li>:CONTrol[:DATA] on page 1044
CALCulate<n>:LIMit<li>:LOWer[:DATA] on page 1046
CALCulate<n>:LIMit<li>:UPPer[:DATA] on page 1049
Insert Value
Inserts a data point in the limit line above the selected one in the "Edit Limit Line" dia-
log box.
Delete Value
Deletes the selected data point in the "Edit Limit Line" dialog box.
Shift x
Shifts the x-value of each data point horizontally by the defined shift width (as opposed
to an additive offset defined for the entire limit line, see " X-Offset " on page 476).
Remote command:
CALCulate<n>:LIMit<li>:CONTrol:SHIFt on page 1045
Shift y
Shifts the y-value of each data point vertically by the defined shift width (as opposed to
an additive offset defined for the entire limit line, see " Y-Offset " on page 477).
Remote command:
CALCulate<n>:LIMit<li>:LOWer:SHIFt on page 1047
CALCulate<n>:LIMit<li>:UPPer:SHIFt on page 1051
Save
Saves the currently edited limit line under the name defined in the "Name" field.
Import
Opens a file selection dialog box and loads the limit line from the selected file in .CSV
format.
Note that a valid import file must contain a minimum of required information for the
R&S FSV/A.
For details on the file format see Chapter 9.4.2.4, "Reference: Limit Line File Format",
on page 485.
Remote command:
MMEMory:LOAD<n>:LIMit on page 1055
Export
Opens a file selection dialog box and stores the currently displayed limit line to the
defined file in .CSV format.
For details on the file format see Chapter 9.4.2.4, "Reference: Limit Line File Format",
on page 485.
The limit line can be imported again later by the R&S FSV/A for use in other measure-
ments.
Remote command:
MMEMory:STORe<n>:LIMit on page 1055
Display and Limit Lines