Appendix: LAN Interface
R&S
®
FSVA/FSV
1057Operating Manual 1176.7510.02 ─ 09
To integrate the instrument into your network, you can change the following system
properties:
●
Computer name
●
Domain
●
Workgroup
7.1.1 Changing the Computer Name
1. Press the SETUP function key on the front panel of the R&S FSVA/FSV.
2. Press the "General Setup" softkey.
3. Press the "Network Address" softkey.
The submenu is displayed.
4. Press the "Computer Name" softkey and enter the computer name.
5. If you enter an invalid name, the error "message out of range" is displayed in the
status line. The edit dialog box remains open, and you can start again.
If the settings are correct, the configuration is saved, and you are prompted to
restart the instrument.
6. Confirm the displayed message ("Yes" button) to restart the instrument.
7.1.2 Changing the Domain or Workgroup
Changing settings
Before you change other settings than described here, contact your network adminis-
trator.
1. Press the "Windows" key on the external keyboard or the CTRL + ESC key combi-
nation on your keyboard to access the operating system.
2. Select "Start > Control Panel > System and Security > System".
3. Scroll down to the "Computer name, domain, and workgroup settings" area.
4. Select "Change settings".
Configuring the Network
To Next Page
Loading...
