Instrument Functions
R&S
®
FSVA/FSV
543Operating Manual 1176.7510.02 ─ 09
2. Select the tab that is assigned to the power sensor you want to zero.
3. Press the "Zeroing Power Sensor" button.
A dialog box is displayed that prompts you to disconnect all signals from the input
of the power sensor.
4. Disconnect all signals from the input of the power sensor and press ENTER to con-
tinue.
5. Wait until zeroing is complete.
A corresponding message is displayed.
3.9.3 Configuring an External Power Trigger
Power Sensors can be used to trigger a measurement at a specified power level, e.g.
from a signal generator.
Currently, the following power sensors are supported:
●
R&S NRP-Zxy
●
NRP8S/SN
●
NRP18S/N
●
NRP33S/SN
As of firmware version 1.60 (with an appropriate detector board as of version 5.00), the
power sensors can be connected to the "Power Sensor" interface directly, and no fur-
ther cables are required. They can then be configured as an external trigger or a power
sensor trigger. The measured power results are displayed as usual.
The previous connection and configuration of a power sensor as an external trigger is
still supported. It is not necessary to change an existing trigger setup unless you want
to evaluate the measured power results further.
Instrument Functions - Power Sensor (R&S FSV-K9)
To Next Page
Loading...
