Rohde & Schwarz FSVA - CALCulate:MARKer:FUNCtion:POWer Subsystem

Remote Control
R&S
®
FSVA/FSV
698Operating Manual 1176.7510.02 ─ 09
bypassed. The first harmonic frequency is set by a specific center frequency in
zero span before the harmonic measurement is started.
Suffix:
<n>
.
Selects the measurement window.
<m> irrelevant
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:MARK:FUNC:HARM ON
Activates the harmonic distortion measurement.
Manual operation: See "Harmonic Distortion" on page 313
See "Harmonic Distortion" on page 414
CALCulate:MARKer:FUNCtion:POWer Subsystem
The CALCulate:MARKer<m>:FUNCtion:POWER subsystem contains the commands
for control of power measurement.
Further information
●
"Predefined CP/ACLR Standards" on page 711
CALCulate<n>:MARKer<m>:FUNCtion:POWer:MODE...................................................... 698
CALCulate<n>:MARKer<m>:FUNCtion:POWer:PRESet.................................................... 699
CALCulate<n>:MARKer<m>:FUNCtion:POWer:RESult?....................................................700
CALCulate<n>:MARKer<m>:FUNCtion:POWer:RESult:PHZ.............................................. 703
CALCulate<n>:MARKer<m>:FUNCtion:POWer:SELect..................................................... 703
CALCulate<n>:MARKer<m>:FUNCtion:POWer[:STATe]....................................................704
CALCulate<n>:MARKer<m>:FUNCtion:POWer:STANdard:CATalog?................................. 705
CALCulate<n>:MARKer<m>:FUNCtion:POWer:STANdard:DELete.....................................705
CALCulate<n>:MARKer<m>:FUNCtion:POWer:STANdard:SAVE....................................... 705
CALCulate<n>:MARKer<m>:FUNCtion:POWer:MODE <Mode>
This commands defines the method by which the channel power values are calculated
from the current trace in the window specified by the suffix <n>.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Remote Control – Commands