Appendix: LAN Interface
R&S
®
FSVA/FSV
1060Operating Manual 1176.7510.02 ─ 09
7.1.7 The Automatic Login Function
When shipped, the instrument is already configured to automatically log on to Win-
dows 7 using the default administrator account ("Instrument") and password.
Deactivating the automatic login function
To deactivate the automatic login function, perform the following steps:
1.
Select the "Windows" icon in the toolbar to access the operating system of the
R&S FSVA/FSV (see also Chapter 2.2.5.4, "Accessing the Start Menu",
on page 47).
2. In the "Start" menu, select "Run".
The "Run" dialog box is displayed.
3. Enter the command C:\R_S\INSTR\USER\NO_AUTOLOGIN.REG.
4. Press the ENTER key to confirm.
The automatic login function is deactivated. The next time you switch on the instru-
ment, you are prompted to enter your user name and password before the firm-
ware is started.
Adapting the automatic login function to a new password
If you change the "Instrument" user's (administrator's) password, which is used during
automatic login, this function no longer works. You must adapt the settings for the com-
mand that activates the auto login function first.
1. Open the C:\R_S\INSTR\USER\NO_AUTOLOGIN.REG file in any text editor (e.g.
Notepad).
2. In the line "DefaultPassword"="894129", replace the default password
(894129) by the new password which is to be used for automatic login.
3. Save the changes to the file.
Re-activating the automatic login function
1. In the "Start" menu, select "Run".
The "Run" dialog box is displayed.
2. Enter the command C:\R_S\INSTR\USER\AUTOLOGIN.REG.
3. Press the ENTER key to confirm.
The automatic login function is re-activated. It will be applied the next time the
instrument is rebooted.
Configuring the Network
To Next Page
Loading...
