Rohde & Schwarz FSVA - 3.2.9.1 Softkeys of the Trigger Menu

Instrument Functions
R&S
®
FSVA/FSV
268Operating Manual 1176.7510.02 ─ 09
●
Chapter 3.2.9.3, "Using Gated Sweep Operation", on page 276
3.2.9.1 Softkeys of the Trigger Menu
The following table shows all softkeys available in the "Trigger" menu. It is possible
that your instrument configuration does not provide all softkeys. If a softkey is only
available with a special option, model or (measurement) mode, this information is pro-
vided in the corresponding softkey description.
Trg/Gate Source..........................................................................................................268
└ Free Run.......................................................................................................269
└ External.........................................................................................................269
└ Video.............................................................................................................269
└ RF Power......................................................................................................269
└ IF Power/BB Power.......................................................................................270
└ Power Sensor............................................................................................... 270
└ Time..............................................................................................................271
└ Digital IQ....................................................................................................... 271
Trg/Gate Level............................................................................................................ 272
Trg/Gate Polarity.........................................................................................................272
Trigger Offset.............................................................................................................. 272
Repetition Interval....................................................................................................... 273
Trigger Hysteresis.......................................................................................................273
Trigger Holdoff............................................................................................................ 273
Gated Trigger..............................................................................................................274
Gate Settings.............................................................................................................. 274
└ Gate Mode (Lvl/Edge)...................................................................................274
└ Gate Delay....................................................................................................274
└ Gate Length (Gate Mode Edge)....................................................................275
└ Trg/Gate Source........................................................................................... 275
└ Trg/Gate Level.............................................................................................. 275
└ Trg/Gate Polarity...........................................................................................275
└ Sweep Time..................................................................................................275
└ Res BW Manual............................................................................................275
Trg/Gate Source
Opens the "Trigger/Gate Source" dialog box to select the trigger/gate mode.
As gate modes, all modes except "Power Sensor" are available. For details see also
Chapter 3.2.9.3, "Using Gated Sweep Operation", on page 276.
The default setting is "Free Run". If a trigger mode other than "Free Run" has been set,
the enhancement label "TRG" is displayed and the trigger source is indicated.
Note: When triggering or gating is activated, the squelch funciton is automatically dis-
abled (see "Squelch" on page 291).
IF power and RF power triggers are not available together with the bandwidth exten-
sion option R&S FSV-B160.
Remote command:
TRIGger<n>[:SEQuence]:SOURce on page 909
[SENSe:]SWEep:EGATe:SOURce on page 854
Measurement Parameters