Rohde & Schwarz FSVA - SOURce:POWer Subsystem

Remote Control
R&S
®
FSVA/FSV
868Operating Manual 1176.7510.02 ─ 09
Suffix:
<n>
.
1...4
Selects the measurement window.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
SOUR2:FM:STAT ON
Switches on the external frequency modulation of the tracking
generator for screen B.
Usage: SCPI confirmed
Manual operation: See "External FM" on page 478
See "Modulation OFF" on page 478
SOURce<n>:FREQuency:OFFSet <Offset>
This command defines a frequency offset of the tracking generator. Frequency-con-
verting DUTs can be measured with this setting.
External I/Q modulation is switched off, if active. This command is available with a
tracking generator (option R&S FSV-B9).
Suffix:
<n>
.
1...4
Selects the measurement window.
Parameters:
<Offset> Note that the values (start frequency – tracking frequency offset)
and (stop frequency – tracking frequency offset) are both > 1
kHz or both < –1 kHz.
Range: -200 MHz to 200 MHz
*RST: 0 Hz
Example:
SOUR:FREQ:OFFS 10MHz
Defines a frequency offset of the tracking generator of 10 MHz.
Usage: SCPI confirmed
Manual operation: See "Frequency Offset" on page 485
SOURce:POWer Subsystem
The SOURce:POWer subsystem controls the power of the tracking generator signal
(only with R&S FSVA/FSV option B9 or B10).
SOURce<n>:POWer[:LEVel][:IMMediate][:AMPLitude].......................................................869
SOURce<n>:POWer[:LEVel][:IMMediate]:OFFSet.............................................................869
SOURce<n>:POWer:MODE............................................................................................869
SOURce<n>:POWer:STARt............................................................................................870
SOURce<n>:POWer:STOP.............................................................................................870
Remote Control – Commands