Rohde & Schwarz FSVA - CALCulate:LIMit Subsystem

Remote Control
R&S
®
FSVA/FSV
636Operating Manual 1176.7510.02 ─ 09
<k> 1 | 2
Selects the frequency line.
Parameters:
<Frequency> Range: 0 Hz to fmax
*RST: (STATe to OFF)
Example:
CALC:FLIN2 120MHz
Manual operation: See "Frequency Line 1 / Frequency Line 2 " on page 420
CALCulate<n>:FLINe<k>:STATe <State>
This command turns a frequency line on and off.
Suffix:
<n>
.
Selects the measurement window.
<k> 1 | 2
Selects the frequency line.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:FLIN2:STAT ON
Manual operation: See "Frequency Line 1 / Frequency Line 2 " on page 420
CALCulate:LIMit Subsystem
The CALCulate:LIMit subsystem contains commands for the limit lines and the corre-
sponding limit checks. Limit lines can be defined as upper or lower limit lines. The indi-
vidual Y values of the limit lines correspond to the values of the x-axis (CONTrol). The
number of X and Y values must be identical. For details on limit lines refer to Chap-
ter 3.3.7, "Using Limit Lines and Display Lines – LINES Key", on page 415.
Further information
●
Chapter 4.3.3, "Limit Lines and Limit Test", on page 1020
CALCulate<n>:LIMit<k>:ACTive?.................................................................................... 637
CALCulate<n>:LIMit<k>:CLEar[:IMMediate]......................................................................637
CALCulate<n>:LIMit<k>:COMMent..................................................................................637
CALCulate<n>:LIMit<k>:COPY........................................................................................637
CALCulate<n>:LIMit<k>:DELete......................................................................................638
CALCulate<n>:LIMit<k>:FAIL?........................................................................................ 638
CALCulate<n>:LIMit<k>:NAME....................................................................................... 639
CALCulate<n>:LIMit<k>:STATe.......................................................................................640
CALCulate<n>:LIMit<k>:UNIT......................................................................................... 640
CALCulate<n>:LIMit<k>:TRACe...................................................................................... 640
Remote Control – Commands